![]() The charging process returns the lead sulphate and water to their original states. The lead plates and electrolyte, which transform into lead sulphate and water during discharge are changed back to lead antimony (Conventional battery), or lead calcium (AGM battery). In addition, charging a battery reverses the destructive chemical process (sulphation) that takes place as the battery is discharged. Battery chargers send direct current (DC) into the battery flowing in the opposite direction of current when the battery discharges. Smart ChargersĪ battery charger brings a new battery, or a battery that has been discharged, to full capacity. The plates of an unsealed battery will begin to oxidize making it more difficult to charge later. Once it’s unsealed, a battery should be activated, charged and installed. The battery is filled with electrolyte from the container when it’s ready to be activated. These batteries are sometimes referred to as Bottle Supplied (BS) because they are shipped with the electrolyte stored in a plastic container. The other type of battery is shipped dry and can be either a Conventional or AGM type of battery. These batteries must be used within a period of time and cannot be stored indefinitely. ![]() Yuasa batteries come from the factory in one of two ways: Factory Activated (FA) where the battery is filled with electrolyte, sealed and charged at the factory. Even if the battery sensor is original equipment (OE) it must be changed when replacing the battery because it may not match the new battery. This indicates that it’s time to add water to the battery.īattery sensors are matched to each battery and are not interchangeable. The sensor indicates battery electrolyte level by flashing a warning light on the vehicle’s instruments panel. Many powersports vehicles that use Conventional batteries come equipped from the factory with battery sensors. If the bike will not be operated for long periods of time the AGM or YuMicron batteries are a good choice. If the engine has been modified and has higher compression or larger displacement, a battery with more starting capacity like the High Performance AGM types would work well. Be careful when matching a new battery with what’s installed in the vehicle-make sure that it is the correct battery or the same “problem” may be repeated causing the battery to be replaced again. Yuasa may list more than on battery for a specific vehicle. There are two sources for identifying the right battery for an application.įind the right battery for your motorcycle here Battery problems are often caused by the selection of the wrong battery for a specific application. Selecting the right battery is an important decision as it will ultimately affect customer satisfaction. Battery Selection, Activation & Charging for motorcycle and powersport batteries
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |